github/acrn-hypervisor
1
0
Fork 0
mirror of https://github.com/projectacrn/acrn-hypervisor.git synced 2026-06-08 10:04:42 +00:00
Code Issues Projects Releases Wiki Activity

doc: remove vuart configuration in nuc and up2

Browse Source 
As the vuart config option is not support anymore, remove it.

Signed-off-by: Conghui Chen <conghui.chen@intel.com>
This commit is contained in:
Conghui Chen
2019-07-16 18:06:40 +00:00
committed by David Kinder
parent e729b657c0
commit 87558b6f98
2 changed files with 4 additions and 9 deletions
Download Patch File Download Diff File Expand all files Collapse all files

7
doc/getting-started/apl-nuc.rst
View File

@@ -429,7 +429,7 @@ partition. Follow these steps:
double-check the platform boot order using ``efibootmgr -v`` and
modify it if needed.
The ACRN hypervisor (``acrn.efi``) accepts three command-line parameters that
The ACRN hypervisor (``acrn.efi``) accepts two command-line parameters that
tweak its behavior:
1. ``bootloader=``: this sets the EFI executable to be loaded once the hypervisor
@@ -450,11 +450,6 @@ partition. Follow these steps:
You should run ``dmesg |grep ttyS0`` to get port address from the output, and then
add the ``uart`` parameter into the ``efibootmgr`` command.
#. ``vuart=ttySn@irqN``: this tells the hypervisor which virtual serial device SOS
will use and its IRQ number. This is used to avoid conflict with SOS passthrough
devices' interrupt. If UART is set to ttyS1, and its native IRQ is 5, you'd better
set ``vuart=ttyS1@irq5`` (Use 'dmesg | grep tty' to get IRQ information).
Also set ``console=ttyS1`` in ``acrn.conf`` to match the SOS boot args.
Here is a more complete example of how to configure the EFI firmware to load the ACRN
hypervisor and set these parameters.