assign 2 CPUs for WaaG and add 1 YaaG on hybrid_rt scenario for
WHL/EHL/TGL/CFL boards.
Tracked-On: #5390
Signed-off-by: Shuang Zheng <shuang.zheng@intel.com>
Acked-by: Victor Sun <victor.sun@intel.com>
update config xmls to make ivshmem size in decimal MB at description
and values.
Tracked-On: #4853
Signed-off-by: Shuang Zheng <shuang.zheng@intel.com>
Acked-by: Victor Sun <victor.sun@intel.com>
Use vm_type to configure the load_type/uuid/severity,
Delete uuid lines in config scenario.
Tracked-On: #4641
Signed-off-by: Shixiong Zhang <shixiongx.zhang@intel.com>
Reviewed-by: Victor Sun <victor.sun@intel.com>
enable TPM2 config on ehl-crb-b board and update TPM2 configs on
legacy boards.
Tracked-On: #5266
Signed-off-by: Shuang Zheng <shuang.zheng@intel.com>
Reviewed-by: Victor Sun <victor.sun@intel.com>
After below commit in https://github.com/zephyrproject-rtos/zephyr
commit d0126a037d23484feebba00d2c0eac27e6393fef
Author: Zide Chen <zide.chen@intel.com>
Date: Wed Feb 5 08:32:00 2020 -0800
boards/x86/acrn: build it in x86_64 mode and switch to X2APIC
The zephyr image for acrn would be built in x86_64 mode by default, then the
load/entry address for pre-launched Zephyr image should be changed from
0x100000 to 0x8000 accordingly per below definition in zephyr .ld file:
zephyrproject_src/zephyr/include/arch/x86/intel64/linker.ld
SECTIONS
{
/*
* The "locore" must be in the 64K of RAM, so that 16-bit code (with
* segment registers == 0x0000) and 32/64-bit code agree on addresses.
* ... there is no 16-bit code yet, but there will be when we add SMP.
*/
.locore 0x8000 : ALIGN(16)
{
_locore_start = .;
The commit in zephyrproject is merged before zephyr v2.2 release, so from v2.2
on, HV need this fix to boot Zephyr as pre-launched VM.
Tracked-On: #5259
Signed-off-by: Victor Sun <victor.sun@intel.com>
add shm_region config in default launch XMLs to configure Inter-
VM communication for post-launched VMs.
Tracked-On: #4853
Signed-off-by: Shuang Zheng <shuang.zheng@intel.com>
Acked-by: Victor Sun <victor.sun@intel.com>
add IVSHMEM_ENABLED and IVSHMEM_REGION in scenario xmls to support
Inter-VM communications configuration for VMs.
v2: move IVSHMEM config into <FEATURES> section
Tracked-On: #4853
Signed-off-by: Shuang Zheng <shuang.zheng@intel.com>
Acked-by: Victor Sun <victor.sun@intel.com>
Add cpu_affinity setup for SOS VM. Cpu affinity must be set in
scenario XML, except if no pre-launched VM on the scenario and
all pCPUs will be assigned to SOS VM in that case;
Tracked-On: #5077
Signed-off-by: Wei Liu <weix.w.liu@intel.com>
Add xmls/samples folders under misc/vm_configs, and make soft link for
them.
Tracked-On: #5077
Signed-off-by: Wei Liu <weix.w.liu@intel.com>
Acked-by: Victor Sun <victor.sun@intel.com>
