When the virtio-XXX pci devices fall back to legacy PCI intx,
the pci_irq_assert is called to inject the interrupt and then
the pci_irq_deassert is used to mark the completion of PCI interrupt.
Currently the HV vIOAPIC uses the pin_state for the interrupt injection
of legacy PCI intx. In such case it will fail to inject the PCI legacy
intx and the guest system fails to be booted when adding the boot option
of "pci=nomsi".
PCI legacy INTx usually use active low level trigger mode as it is Open-Drain
state and allows multitple interrupt signals to share a single line.
https://wiki.osdev.org/PCI_Local_Bus_Signals
In such case DM needs to set the correct state for the PCI device so that the
HV vIOAPIC can help to inject the PCI legacy intx.
BTW: When the MSI/MSIX is used for PCI device, it uses another mechanism
to inject the interrupt. It is harmless to configure the initial state.
Tracked-On: #7124
Signed-off-by: Zhao Yakui <yakui.zhao@intel.com>
Acked-by: Wang, Yu1 <yu1.wang@intel.com>
cleanup 'assert' usage to avoid possible software vulnerabilities
Tracked-On: #3252
Signed-off-by: Yonghua Huang <yonghua.huang@intel.com>
Reviewed-by: Shuo A Liu <shuo.a.liu@intel.com>
- remove ASSERT & DEASSET IRQ line IOCTLs
- remove PULSE IRQ line IOCTLs, use set/clear
IRQ line instead.
- Use IC_SET_IRQLINE to set or clear IRQ line
Tracked-On: #861
Signed-off-by: Yonghua Huang <yonghua.huang@intel.com>
Reviewed-by: Jason Chen CJ <jason.cj.chen@intel.com>
Reviewed-by: Eddie Dong <eddie.dong@intel.com>
Acked-by: Anthony Xu <anthony.xu@intel.com>
