mirror of
https://github.com/projectacrn/acrn-hypervisor.git
synced 2026-06-08 10:04:42 +00:00
369547aa63
1. modify epc_section to configurable="0". 2. add 'idle=halt' for sos bootargs to impove performance. Tracked-On: #4641 Signed-off-by: Wei Liu <weix.w.liu@intel.com> Acked-by: Victor Sun <victor.sun@intel.com>
28 lines
1.8 KiB
XML
28 lines
1.8 KiB
XML
<acrn-config board="" scenario="">
|
|
<vm id="0" configurable="1" desc="specific for Kata">
|
|
<vm_type readonly="true" desc="Specify the VM by its load order: PRE_LAUNCHED_VM, SOS_VM or POST_LAUNCHED_VM.">KATA_VM</vm_type>
|
|
<clos configurable="0" desc="Class of Service for Cache Allocation Technology. Please refer SDM 17.19.2 for details and use with caution.">
|
|
<vcpu_clos>0</vcpu_clos>
|
|
</clos>
|
|
<vcpu_affinity desc="vCPU affinity map. Each vCPU will pin to the selected pCPU ID. Please make sure each vCPU pin to different pCPU.">
|
|
<pcpu_id></pcpu_id>
|
|
</vcpu_affinity>
|
|
<epc_section configurable="0" desc="epc section">
|
|
<base desc="SGX EPC section base, must be page aligned"></base>
|
|
<size desc="SGX EPC section size in Bytes, must be page aligned"></size>
|
|
</epc_section>
|
|
<vuart id="0">
|
|
<type configurable="0" desc="vCOM1 type">VUART_LEGACY_PIO</type>
|
|
<base configurable="0" desc="vUART0 (A.K.A COM1) enabling switch. Enable by exposing its base address, disable by returning invalid base address.">INVALID_COM_BASE</base>
|
|
<irq configurable="0" desc="vCOM1 irq">COM1_BASE</irq>
|
|
</vuart>
|
|
<vuart id="1">
|
|
<type configurable="0" desc="vCOM2 type">VUART_LEGACY_PIO</type>
|
|
<base configurable="0" desc="vUART1 (A.K.A COM2) enabling switch. Enable by exposing its base address, disable by returning invalid base address.">INVALID_COM_BASE</base>
|
|
<irq configurable="0" desc="vCOM2 irq">COM2_BASE</irq>
|
|
<target_vm_id desc="COM2 is used for VM communications. When it is enabled, please specify which target VM that current VM connect to."></target_vm_id>
|
|
<target_uart_id configurable="0" desc="target vUART ID that vCOM2 connect to">0</target_uart_id>
|
|
</vuart>
|
|
</vm>
|
|
</acrn-config>
|