CDP is an extension of CAT. It enables isolation and separate prioritization of
code and data fetches to the L2 or L3 cache in a software configurable manner,
depending on hardware support.
This commit adds a Kconfig switch "CDP_ENABLED" which depends on "RDT_ENABLED".
CDP will be enabled if the capability available and "CDP_ENABLED" is selected.
Tracked-On: #4604
Signed-off-by: Yan, Like <like.yan@intel.com>
Reviewed-by: Vijay Dhanraj <vijay.dhanraj@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
This commit makes some RDT code cleanup, mainling including:
- remove the clos_mask and mba_delay validation check in setup_res_clos_msr(), the check will be done in pre-build;
- rename platform_clos_num to valid_clos_num, which is set as the minimal clos_mas of all enabled RDT resouces;
- init the platform_clos_array in the res_cap_info[] definition;
- remove the unnecessary return values and return value check.
Tracked-On: #4604
Signed-off-by: Yan, Like <like.yan@intel.com>
A RDT resource could be CAT or MBA, so only one of struct rdt_cache and struct rdt_membw
would be used at a time. They should be a union.
This commit merge struct rdt_cache and struct rdt_membw in to a union res.
Tracked-On: #4604
Signed-off-by: Yan, Like <like.yan@intel.com>
Reviewed-by: Vijay Dhanraj <vijay.dhanraj@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com
This patch adds RDT MBA support to detect, configure and
and setup MBA throttle registers based on VM configuration.
Tracked-On: #3725
Signed-off-by: Vijay Dhanraj <vijay.dhanraj@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
cache configuration.
This patch creates a generic infrastructure for
RDT resources instead of just L2 or L3 cache. This
patch also fixes L3 CAT config overwrite by L2 in
cases where both L2 and L3 CAT are supported.
Tracked-On: #3715
Signed-off-by: Vijay Dhanraj <vijay.dhanraj@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
There can be times when user unknowinlgy enables
CONFIG_CAT_ENBALED SW flag, but the hardware might
not support L3 or L2 CAT. In such case software can
end up writing to the CAT MSRs which can cause
undefined results. The patch fixes the issue by
enabling CAT only when both HW as well software
via the CONFIG_CAT_ENABLED supports CAT.
The patch also address typo with "clos2prq_msr"
function name. It should be "clos2pqr_msr" instead.
PQR stands for platform qos register.
Tracked-On: #3715
Signed-off-by: Vijay Dhanraj <vijay.dhanraj@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
As part of rdt cat refactoring, goal is to combine all rdt
specific features such as CAT under one module. So renaming
rdt resouce specific files such as cat.c/.h to generic rdt.c/.h
files.
Tracked-On: #3715
Signed-off-by: Vijay Dhanraj <vijay.dhanraj@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
