with this patch guest could access idle io port and enter idle normally.
Signed-off-by: Victor Sun <victor.sun@intel.com>
Acked-by: Kevin Tian <kevin.tian@intel.com>
Each VM would have its own Cx data, for now we copy it from boot_cpu_info.
Signed-off-by: Victor Sun <victor.sun@intel.com>
Acked-by: Kevin Tian <kevin.tian@intel.com>
The cx data is hardcoded within HV, load it to boot_cpu_data when HV boot.
The patch provide a3960 soc cx data for example.
Signed-off-by: Victor Sun <victor.sun@intel.com>
Acked-by: Kevin Tian <kevin.tian@intel.com>
currently, pass-thru devices are managed by per-vm's remapping entries
which is virtual based:
- MSI entry is identified by virt_bdf+msix_index
- INTx entry is identified by virt_pin+vpin_src
it works but it's not a good design for physical resource management, for
example a physical IOAPIC pin could belong to different vm's INTx entries,
the Device Model then must make sure there is no resource conflict from
application's level.
This patch change the design from virtual to physical based:
- MSI entry is identified by phys_bdf+msix_index
- INTx entry is identified by phys_pin
The physical resource is directly managed in hypervisor, a miss adding
entry will be found by hypervisor and return error message with failure.
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Xu, Anthony <anthony.xu@intel.com>
add initialize_timer to initialize or reset a timer;
add_timer add timer to corresponding physical cpu timer list.
del_timer delete timer from corresponding physical cpu timer list.
Signed-off-by: Li, Fei1 <fei1.li@intel.com>
Get tsc hz by cpuid 0x15 if we supported, otherwise
calibrate tsc by pit timer.
Signed-off-by: Li, Fei1 <fei1.li@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
If guest reboot is issued before trusty init hypercall is issued,
we shouldn't destroy ept fo trusty memory because the ept is not
created yet.
Signed-off-by: Yin Fengwei <fengwei.yin@intel.com>
Reviewed-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Anthony Xu <anthony.xu@intel.com>
Using eax will truncate the high 32bit part of 64bit virtual address.
And the type of sync is unsigned long, so using rbx instead of ebx.
Signed-off-by: Zheng, Gen <gen.zheng@intel.com>
Reviewed-by: Zhao Yakui <yakui.zhao@intel.com>
This is to do the clean-up of IOAPIC mmio-access. Use the same API to
access the IOAPIC register. At the same time it also helps to avoid the
optimization in direct access mode.(The volatile is already added in
mmio_read_long/mmio_write_long)
V1->V2: Follow Fengwei's suggestion to use the mmio_read/write_long
Signed-off-by: Zhao Yakui <yakui.zhao@intel.com>
Reviewed-by: Yin Fengwei <fengwei.yin@intel.com>
Now just add some basic feature/capability detect (not all). Vapic
didn't add here for if we must support vapic then the code which
for vapic not supported must remove, like mmio apic r/w.
Signed-off-by: Li, Fei1 <fei1.li@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
Split pm.c from cpu_state_tbl.c to put guest power management related
functions, keep cpu_state_tbl.c to store host cpu state table and
related functions.
Signed-off-by: Victor Sun <victor.sun@intel.com>
Acked-by: Kevin Tian <kevin.tian@intel.com>
for timer list is operated by per-cpu; and no interrupt
service operates it too. So it's unnecessary for spinlock.
Signed-off-by: Minggui Cao <minggui.cao@intel.com>
Reviewed-by: Yin Fengwei <fengwei.yin@intel.com>
Reviewed-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
adding "hugepagesz=1G" and "hugepages=X" into SOS cmdline, for X, current
strategy is making it equal
e820_mem.total_mem_size -CONFIG_REMAIN_1G_PAGES
if CONFIG_REMAIN_1G_PAGES is not set, it will use 3 by default.
CONFIG_CMA is added to indicate using cma cmdline option for SOS kernel,
by default system will use hugetlb cmdline option if no CONFIG_CMA defined.
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Xu, Anthony <anthony.xu@intel.com>
change its input from map_params to page_table_type, and make it as a
public API.
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Xu, Anthony <anthony.xu@intel.com>
before just AP can run "rdtscp" intruction, if run it on BSP,
it will cause "illegal instruction"; now align BSP & AP.
also remove duplicated code.
Signed-off-by: Minggui Cao <minggui.cao@intel.com>
Acked-by: Anthony Xu <anthony.xu@intel.com>
1. exception vector and other information
can be extracted from 'VM-Exit Interrupt-Information'
field of VMCS only if bit31 (Valid) is set.
-Intel SDM 24.9.2, Vol3
2. Rename 'exit-interrupt_info' to 'idt_vectoring_info'
in 'struct vcpu_arch', which is consistent with
SDM 24.9.3, Vol3
3. 'IDT-vectoring information' in VMCS is 32bit
-Intel SDM 24.9.3, Vol3
Update the type of 'idt_vectoring_info' in
'struct vcpu_arch'from 'uint32_t' to 'uint64_t'.
Signed-off-by: Yonghua Huang <yonghua.huang@intel.com>
Before referencing to physical address of devs such as lapic, ioapic,
vtd, and uart, switch to virtual address.
Use a phisical address of pml4 to write CR3.
Signed-off-by: Zheng, Gen <gen.zheng@intel.com>
SDM 24.9.1 Volume3:
- 'Exit reason' field in VMCS is 32 bits.
SDM 24.9.4 in Volume3
- 'VM-exit instruction length' field
in VMCS is 32 bits.
This patch is to redefine the data types of above fields
in 'struct vcpu_arch' and udpate the code using these
two fields.
Signed-off-by: Yonghua Huang <yonghua.huang@intel.com>
Since we get cpu feature/capability in boot_cpu_data at boot initialization,
then there no need to get this feature/capability using cpuid again.
Signed-off-by: Li, Fei1 <fei1.li@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
Update X86_FEATURE_OSXSAVE when enabled and replace is_xsave_supported
with cpu_has_cap(X86_FEATURE_OSXSAVE).
Signed-off-by: Li, Fei1 <fei1.li@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
Add cpu_has_cap API for cpu feature/capability detect instead of
add get_xxx_cap for each feature/capability detect.
Signed-off-by: Li, Fei1 <fei1.li@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
remove data defination of mmio_addr_t, vaddr_t, paddr_t,
and ioport_t.
Signed-off-by: Zheng, Gen <gen.zheng@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
Signed-off-by: Zheng, Gen <gen.zheng@intel.com>
This address maybe invalid if a hostile address was set
in hypercall 'HC_SET_IOREQ_BUFFER'.it should be validated
before using.
Update:
-- save HVA to guest OS's request buffer in hyperviosr
-- change type of 'req_buf' from 'uint64_t' to 'void *'
-- remove HPA to HVA translation code when using this addr.
-- use error number instead of -1 when return error cases.
Signed-off-by: Yonghua Huang <yonghua.huang@intel.com>
This is workaround patch to resolve Disti performance issue.
In kernel 4.14, PAT is skipped to initialize if MTRR is not enabled,
while graphics driver need set WC to GGTT memory to accelerate memcpy,
if PAT is not initialized, default PAT register will treat UC- as
uncacheable, which will impact gfx performance. Change PAT default
register value to treat UC- as WC to workaroud this problem.
Revert me when PAT/MTRR strong correlation is removed in kernel.
Signed-off-by: Fei Jiang <fei.jiang@intel.com>
Switch all the referenced virtual address to physical address
include ept mapping, vmcs field, vmxon, vmclear, and vmptrld.
Signed-off-by: Zheng, Gen <gen.zheng@intel.com>
Reviewed-by: Chen, Jason Cl <jason.cj.chen@intel.com>
Reviewed-by: Yakui, Zhao <yakui.zhao@intel.com>
Signed-off-by: Zheng, Gen <gen.zheng@intel.com>
Before using a node of list, initialize it.
Signed-off-by: Zheng, Gen <gen.zheng@intel.com>
Reviewed-by: Yakui, Zhao <yakui.zhao@intel.com>
Reviewed-by: Chen, Jason Cl <jason.cj.chen@intel.com>
Guest OS rdtsc/rdtscp doesn't trap into hypervisor, so remove them.
Signed-off-by: Minggui Cao <minggui.cao@intel.com>
Reviewed-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
if failed to allocate page structure for root_table or context_table,
ASSERT system and return.
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Tian, Kevin <kevin.tian@intel.com>
add necessary HPA2HVA/HVA2HPA transition for context_table_addr
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Tian, Kevin <kevin.tian@intel.com>
Acked-by: Xu, Anthony <anthony.xu@intel.com>
add necessary HPA2HVA/HVA2HPA transition for root_table_addr
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Tian, Kevin <kevin.tian@intel.com>
Acked-by: Xu, Anthony <anthony.xu@intel.com>
when host mmu got updated, it should invalidate TLB & page-struct cache.
currently, there is no mmu update will be done after any AP start, so the
simplest way(to avoid shootdown) is just do invlpg for BSP.
Signed-off-by: Mingqiang Chi <mingqiang.chi@intel.com>
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Tian, Kevin <kevin.tian@intel.com>
Acked-by: Xu, Anthony <anthony.xu@intel.com>
- change the input param of check_page_table_present from struct map_params
to page_table_type
- check EPT present bits misconfiguration in check_page_table_present
- change var "table_present" to more suitable name "entry_present"
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Tian, Kevin <kevin.tian@intel.com>
check IA32_VMX_EPT_VPID_CAP MSR to see if ept execution only capability
is supported or not
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Tian, Kevin <kevin.tian@intel.com>
cpu_halt actually mean cpu dead in current code, so change it with
more clear name.
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Tian, Kevin <kevin.tian@intel.com>
use pcpu_active_bitmap presents which cpu is active
Signed-off-by: Mingqiang Chi <mingqiang.chi@intel.com>
Acked-by: Tian, Kevin <kevin.tian@intel.com>
APIC-access page which write into VMCS should be hpa
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
virtual-ACPI page which write into VMCS should be hpa
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
Guest write tsc: cache the offset into run_context.tsc_offset;
Guest read tsc : use run_context.tsc_offset to calculate guest_tsc.
Signed-off-by: Qi Yadong <yadong.qi@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
Before this patch, guest temporary page tables were generated by hardcode
at compile time, HV will copy this page tables to guest before guest
launch.
This patch creates temporary page tables at runtime for the range of 0~4G,
and create page tables to cover new range(511G~511G+16M) with trusty
requirement.
Signed-off-by: Mingqiang Chi <mingqiang.chi@intel.com>
Reviewed-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
