mirror of
https://github.com/kata-containers/kata-containers.git
synced 2025-05-04 22:47:29 +00:00
a196c85e04
Generated by git subtree add --prefix=docs git@github.com:kata-containers/documentation.git master git-subtree-dir: docs git-subtree-mainline:ec146a1b39git-subtree-split:510287204bFixes: #329 Signed-off-by: Peng Tao <bergwolf@hyper.sh>
48 lines
1.9 KiB
Markdown
48 lines
1.9 KiB
Markdown
# Installing with `kata-manager`
|
|
|
|
* [Introduction](#introduction)
|
|
* [Full Installation](#full-installation)
|
|
* [Install the Kata packages only](#install-the-kata-packages-only)
|
|
* [Further Information](#further-information)
|
|
|
|
## Introduction
|
|
`kata-manager` automates the Kata Containers installation procedure documented for [these Linux distributions](README.md#supported-distributions).
|
|
|
|
> **Note**:
|
|
> - `kata-manager` requires `curl` and `sudo` installed on your system.
|
|
>
|
|
> - Full installation mode is only available for Docker container manager. For other setups, you
|
|
> can still use `kata-manager` to [install Kata package](#install-the-kata-packages-only), and then setup your container manager manually.
|
|
>
|
|
> - You can run `kata-manager` in dry run mode by passing the `-n` flag. Dry run mode allows you to review the
|
|
> commands that `kata-manager` would run, without doing any change to your system.
|
|
|
|
|
|
## Full Installation
|
|
This command does the following:
|
|
1. Installs Kata Containers packages
|
|
2. Installs Docker
|
|
3. Configure Docker to use the Kata OCI runtime by default
|
|
|
|
```bash
|
|
$ bash -c "$(curl -fsSL https://raw.githubusercontent.com/kata-containers/tests/master/cmd/kata-manager/kata-manager.sh) install-docker-system"
|
|
```
|
|
|
|
<!--
|
|
You can ignore the content of this comment.
|
|
(test code run by test-install-docs.sh to validate code blocks this document)
|
|
|
|
```bash
|
|
$ bash -c "$(curl -fsSL https://raw.githubusercontent.com/kata-containers/tests/master/cmd/kata-manager/kata-manager.sh) remove-packages"
|
|
```
|
|
-->
|
|
## Install the Kata packages only
|
|
Use the following command to only install Kata Containers packages.
|
|
|
|
```bash
|
|
$ bash -c "$(curl -fsSL https://raw.githubusercontent.com/kata-containers/tests/master/cmd/kata-manager/kata-manager.sh) install-packages"
|
|
```
|
|
|
|
## Further Information
|
|
For more information on what `kata-manager` can do, refer to the [`kata-manager` page](https://github.com/kata-containers/tests/blob/master/cmd/kata-manager).
|